Brand: MUQZI Product Name: Bicycle Lifter Tail Hook Corrector Material: aluminum alloy + stainless steel Size: 47 * 11 * 16.7cm Weight: 1061 grams Packaging: boxed Packing details: corrector * 1 spare rubber ring * 2 spare wave bead adjustment screw * 1 adjustment wrench * 1 Suitable for: 14 inch / 16 inch / 18 inch / 24 inch / 26 inch / 27.5 inch / 29 inch / 700C Car measurement allowable error: within 1-3MM Features: This product is made of stainless steel + aluminum alloy. The integrated operation lever is CNC machined. The accuracy of the operation lever and head connector is minus 0.02 wire. Press-in design to ensure its accuracy and verticality. The stainless steel bushing is used between the locking screw rod and the head connection, and the internal grinding is used for precision machining, and the wave bead adjustment screw is attached to ensure the maximum tolerance. Notes for use: Before use, please make sure that the wheels are correctly installed and not deflected. The rim is adjusted by the rim adjustment table to avoid affecting the accuracy of the measurement. Between each point of the test, the slider should be fixed with a lock nut to ensure the accuracy of the measurement. Because the tool is a practical product, it is not deliberately lightweight during design, and the strength and precision of the product are always the first to ensure that the tool is durable.
1.Install the nuts 2.Install the test rod 3.Use 2.5 wrench before commissioning Properly tighten this nut to ensure The shaft can turn, but it won't get stuck. 4.Lock the tool screw onto the tail hook 5.Measure four ABCD points of the wheel set in turn 6. Test point B using point A as a benchmark.Then use point C as a benchmark to test point D.If the distance is greater than 3mm, use Tool adjustment. 7.Tighten before testing each point This nut prevents slipping and protects To verify the accuracy of the data. 8.For example, points B and A of this figure A difference of two millimeters is ok,This is within tolerance 9.For example, the distance between point c and d is ok.